![]() are the map coordinates and can be left out. negative amounts can be used to reduce/remove effects.Ĭlears the conquest points for all factions at a certain location in a single square.radial adds the desired amount of conquest points to multiple squares in a gradually decreasing manner, like killing enemies would.set and add influence only a single square.If left out, the current player (or command block) position is affected. ![]() The following commands can be used to set conquest rates:Ĭhange conquest points for one faction at a certain location. In order to keep up high rates, you need to keep on fighting enemies in the desired region. It then decreases by about one point every hour. If you have hired some friends, they will not grant you alignment, but they will, however, grant you some conquest, at the rate of 1/4 the conquest you would earn if you were to kill the units yourself.Ĭonquest decay begins only after there have been no changes in that square for one hour.
0 Comments
Leave a Reply. |